No results were found for the filter!
Art.-Nr. 1162118
Camshaft sprocket without leading edge for toothed belt
€89.95 *
Art.-Nr. 1164063
Fuel pump for injector models Alternative to the BOSCH pump Attention: If your pump is defective, make sure to check whether there is rust or other impurities in your tank, as the fuel is only cleaned after the pump! If you do not take...
€79.90 *
Art.-Nr. 1162180
Attention: Overall height 57 mm Illustration similar
€12.49 *
Art.-Nr. 1176039
€2.75 *
Art.-Nr. 1184015
Material: NBR Outer diameter: 28 mm Inner diameter: 12 mm Height: 7 mm
€5.25 *
Art.-Nr. 1184023
Ignition coil 14/16/1800 Fiat 124 Spider 66-78 from Marelli Outer diameter: 58 mm
€49.95 *
Art.-Nr. 1184035
Fiat 124 Spider/Coupe BS/BS/CS1/ BC/CC 1608 and 1756 cc 1971 - 1978 Abstand from distributor cap edge to contact 63 mm. For Marelli Ignition distributor S144B
€76.95 *
Art.-Nr. 8562070
Fiat 600 - Fiat 600 D - Seat 770 S Fiat 600/D Multipla - Fiat 600 T Fiat 850 all models Fiat 127 (903 cc) Lancia A 112 (903 cc)
€7.90 *
Art.-Nr. 8584027
original MARELLI
€9.90 *
Art.-Nr. 1062567
original TECNOCAR 124 Spider 2000 Lancia Delta Alfa Romeo 145/146
€15.95 *
Art.-Nr. 1064020
Hole spacing: 45 mm
€2.49 *
Art.-Nr. 1072045
Fiat X 1/9 1500 (1979-1988) Lancia Beta Montecarlo (2nd series) Lancia Delta Integrale (rear axle, 1987-1991) Lancia Delta 2000HF 4WD (front and rear axle, 1986-1988) also Fiat Uno, Ritmo, Regata
€29.90 *
Art.-Nr. 1074022
Dimensions: Outer diameter: 75 mm Inner diameter: 58 mm Inner diameter from bulge to bulge: 64 mm Height: 12 mm
€28.55 *
Art.-Nr. 1074028
Fiat X 1/9 1500 rear Lancia Beta front/rear Lancia Gamma rear Dimensions: Outer diameter: 72 mm Inner diameter: 37 mm Width: 37 mm
€31.95 *
Art.-Nr. 1080030
Fiat X 1/9 all models Lancia Beta Monte Carlo
€72.90 *
Art.-Nr. 1082059
€89.90 *
Recommended
Art.-Nr. 1068111
From €289.95 *
Art.-Nr. 1362012
1.3 mm Thickness 88 mm Gasket Bore Diameter Athena's multi-layer cylinder head gaskets are specially engineered to handle increasing cylinder pressures and temperatures. They are used by numerous automotive manufacturers as original...
€199.90 *
Art.-Nr. 1160033
Material: Cork or rubber
€4.95 *
Art.-Nr. 1160054
€3.95 *
Art.-Nr. 1162104
€2.95 *
Art.-Nr. 1162116
Made of metal Inner diameter 30 mm
€56.95 *
Art.-Nr. 1162117
Camshaft sprocket inlet with rear leading edge for toothed belt
€49.95 *
Art.-Nr. 1162143
Oil pump with short splines for drive Up to chassis no.: 152387 Please note before purchasing: Check the wrench size of the nut/bolt at the front of the crankshaft pulley. If you have a 38 mm wrench size (right-hand thread nut), you need...
€139.95 *
Art.-Nr. 1162162
Galvanised sheet metal lid with rubber seal Fiat 600 - Fiat 600 D - Seat 770 S Fiat 850 N/S/Coupe / Spider Fiat 11/1200 - Fiat 1200 Cabrio Fiat 13/1500 - Fiat 1500 C/L Fiat 12/1500 Cabrio - Fiat 2300 Fiat 124 N/S/Coupe / Spider
€5.95 *
Art.-Nr. 1162207
Length 42 mm Outer diameter 15.05 mm Inner diameter 8 mm With Absatz for valve stem seal
€9.95 *
Art.-Nr. 1162249
Set of bearing shells auxiliary shaft Large bearing: Outside 51 mm Inside 48.5 mm Small bearing: Outside 42.5 mm Inside 39 mm Attention: Follow installation instructions
€49.95 *
Art.-Nr. 1164017
For Weber 1978 32ADFA 2/100, 1979-80 WEBER 28/32 ADHA, carburettor idle shut-off valve with 8 x 1.0 mm thread
€36.95 *
Recently Viewed