Tie rod, steering gear - Fiat 124 Coupé

This is only the cage incl. the balls. Attention! The bearing shells are different: Top article no.: 1170083, bottom article no.:1170082. Outer diameter bearing: approx. 41 mm Inner diameter bearing: approx. 28 mm Ball diameter:...

Inner diameter: 28.10 mm Outer diameter: 47.00 mm

Adjusting washer for steering gear fit

Adjusting washer for steering gear fit    

   

used, all up to year of construction 84 up to chassis no.: 5506003    

Lower bearing shell for steering gear shaft to steering column Inner diameter: 32.42 mm Outer diameter: 47.00 mm

Fiat 500 Fiat 600 Fiat 850 Fiat 124 Fiat 238 Fiat 241 Fiat 1500

37 x 19 x 10 mm  

Dimensions: Outer diameter: 36 mm Outer cylinder diameter: 24 mm Inner diameter: 21 mm Height: 18 mm

Shaft with sealing ring for pulley block For DS Euro models 83-84

DS / Volumex up to Fg. No. 5506003

Steering arm for DS models from VIN #5506003# with rack and pinion steering

1x installed, from chassis no.: 5506003 For left side in direction of travel.  

Rack and pinion steering complete with axial joints and tie rod ends from serial no. 5506004

1x present, bushing for steering shaft right

For 124 Spider from chassis no.: 5506003 (with rack-and-pinion steering)    

from chassis no.: 5506003    

1x present set right and left

Inner diameter d 10mm / D 52mm / Length 145mm

Inner diameter d 10mm / D 32mm / Length 190mm For right side in driving direction.

Tie rod end left-hand thread M 14 x 1 Length overall: 94 mm Fiat 500 F/R - Fiat 500 F Giardiniera Fiat 126 - Fiat 126 P Fiat 600 D from VIN 1717594 - Seat 770 S Fiat 850 N/S/Coupe/Spider Fiat 124 N/S - Fiat 124 Coupe/Spider...

with screw and nut Fiat 500 - Fiat 126 - Fiat 600 - Fiat 850 Fiat 124N/S/Coupe/Spider

Tie rod set Fiat 124 Spider for 16/18/2000 Fiat 124 Spider 1x tie rod centre bent 1170062 2x tie rod sleeve 1170065 4x clamp for tie rod sleeve 1170067 2x tie rod end inside right hand thread 1170058 2x tie rod end outside left hand...

Fiat 124 N/S Fiat 124 Coupé/Spider 1966-1968

Tie rod complete one side for year 70-84 Fiat 124 Spider BS - DS 1x tie rod end left hand thread (article no.: 1170057) 1x tie rod end right hand thread (article no.: 1170058) 1x tie rod sleeve (article no.: 1170065) 2x clamp (article...

Fiat 500 F/L/R - Fiat 126 Fiat 600 D from 1964 - Seat 770 S Fiat 850 N/S/Coupe/Spider Fiat 124 N/S/Coupe/Spider

Fiat 124 N/S Fiat 124 Spider DS

Steering arm original used with teeth on idler arm with oil damping 66-82 all, 83-84 only US models    

Steering lever original used up to chassis no.: 5506003 For left side in direction of travel.    

Steering lever original used up to chassis no. 5506003 For right side in direction of travel.    

Ball-bearing mounted pulley block without teeth 83-84 DS Euro (the lever is not included in the scope of delivery) !!Attention!! for the US Spidern DS 83/84 the following article no.: 1170012 must be used.

Idler arm with ball bearings and toothing Fiat 124 Spider 68-84 - Instead of the oil-damped idler arm. Sold without lever. Attention: On the Euro-Spiders (DS) from the years 83-84, the steering lever must be replaced with one with...

Adjustment of the housing required. The oil seals for the steering damper only fit if the housing is unscrewed at the bottom.    

   

Original FIAT steering gear revised.

Steering gear comes without steering arm, your old steering arm is required. Our SERVICE: The conversion requires a special puller! If we receive your old steering gear, we will rebuild the steering arm free of charge!  

Steering gear for right-hand drive Fiat Spider /Coupe from Bj 73-84 usable  

The bearings are located on the gearbox output shaft (there are steering gear versions with brass bushings instead of needle bearings).

The deposit will be refunded if you send us the old part and it has been successfully checked.

Washer For fastening screw of steering gear/steering box to car body  

Electric power steering with TÜV certificate. The kit also includes a speed signal sensor, as there are different speedometer cable types, please note whether the upper speedometer cable connection is a quick release or a screw...

For retrofitting electric power steering. For models with speedometer cable screw cap up to year of manufacture: 76 Fiat 124 Spider / Coupe

The Steering lever bracket has a splined shaft and comes assembled with the steering arm. This idler block is suitable for all Fiat 124 Spider models, except for the 124 Spider DS built in 1985 with rack and pinion steering.