No results were found for the filter!
Art.-Nr. 1160099
Diamond-shaped rubber seal for heating valve and heating pipes of various models Fiat 850 N/, Coupe, Spider Fiat 1100 R Fiat 124 N/S, Coupe, Spider Fiat X 1/9 Fiat Dino Coupe, Spider
€1.75 *
Art.-Nr. 1162019
Engine sealing set with shaft sealing rings (90/70/10 dimension shaft sealing ring, rear engine) We can highly recommend ordering the reinforced cylinder head gasket (item no. 1162043) and installing it instead of the one included in the...
€84.95 *
Art.-Nr. 1162032
Material: Cork
€12.95 *
Art.-Nr. 1162108
Item is similar to the picture
€7.95 *
Art.-Nr. 1162109
Item may differ from picture.
€9.95 *
Art.-Nr. 1162115
With inner diameter 29 mm
€55.95 *
Art.-Nr. 1162118
Camshaft sprocket without leading edge for toothed belt
€89.95 *
Art.-Nr. 1164063
Fuel pump for injector models Alternative to the BOSCH pump Attention: If your pump is defective, make sure to check whether there is rust or other impurities in your tank, as the fuel is only cleaned after the pump! If you do not take...
€79.90 *
Art.-Nr. 1162142
Oil pump incl. oil pump seal for 1800 US models Fiat 124 Spider 1800 USA Fiat 131 Super 1600 Fiat 132/1600
€124.95 *
Art.-Nr. 1162148
Original used, stripped, straightened and repainted. Dimensions: Length: 453mm Width: 228-248mm Height: 125mm
€169.95 *
NEW
Art.-Nr. 1162158
Dimensions: Length: 452 mm Width: 602 mm Pipe outer diameter: 24 mm Pipe inner diameter: 22 mm Material thickness: 4 mm Depth: 14 mm
€119.95 *
Art.-Nr. 1162171
Wide end Inner diameter: 18 mm Outer diameter: 25 mm Narrow end Inner diameter: 9.5 mm Outer diameter: 22 mm
€5.75 *
Art.-Nr. 1162180
Attention: Overall height 57 mm Illustration similar
€12.49 *
Art.-Nr. 1164094
Height : 61 mm Ø Outside : 270 mm Ø Inside : 223 mm
€15.95 *
Art.-Nr. 1162237
The throttle switch contains a contact for idling and full load. The switch contact closes the contacts for idling or full load at a certain throttle setting. The control unit processes the output signals when measuring the injection...
€149.95 *
Art.-Nr. 1164074
Fiat 124 Spider year 77-79 1800/2000 carburettor for deflection on the valve cover Length of inner part approx. 52cm Total length approx. 65cm Be sure to grease sufficiently before installation!
€29.95 *
Art.-Nr. 1164007
Carburettor gasket set 34 DHS with diaphragms, needle valve stem, filter, gaskets, O - rings, U - washers
€29.79 *
Art.-Nr. 1164011
Carburettor gasket set SOLEX 34 EIES with diaphragms, needle valve stem, filter, gaskets, O - rings, U - washers
€49.95 *
Art.-Nr. 1164042
Tank sender with one hose connection
€39.95 *
Art.-Nr. 1166016
Fiat 124 Spider Carburettor models with CAT and 2000 i.e. 75 - 85 Made in Italy Pipe to centre silencer: 42mm inside / 46mm outside
€184.95 *
Art.-Nr. 1166017
Note: Only for vehicles with European original delivery! Dimensions: Outlet diameter: 32 mm
€289.95 *
Art.-Nr. 1166021
Exhaust manifold from 80-85 All models except Turbo, with lambda probe connection
€339.90 *
Art.-Nr. 1166023
Installed directly on the gearbox. Matching front silencer order number: 1166008 Without ABE Pipe diameter: Manifold: 38.5 mm outside 37 mm inside Y-pipe: 46 mm outside 42 mm inside Y-pipe before merging: 40 mm outside 36 mm inside
€509.95 *
Art.-Nr. 1166040
The spring is also suitable for models without a catalytic converter, as the exhaust manifold has two side brackets to which the springs can be attached. Note: Please check your exhaust manifold beforehand to ensure that these two side...
€5.90 *
Recently Viewed