Radiator hose AS top left AS 68-71 1438 ccm (cooling system with thermostat in cylinder head, system with 2 hoses)

Radiator hose AS lower right AS 66-71 1438 cc (cooling system with thermostat in cylinder head, with only 2 radiator hoses) Fiat 124 Spider

Engine gasket set incl. oil seals Engine type 132AC.000/132AC,040 (1592ccm, 80mm bore)

Cylinder head gasket set including shaft seals (year 80-85) We highly recommend ordering the reinforced cylinder head gasket (item no. 1162043) and installing it instead of the one included in the gasket set! The reinforced seal can...

Screw V-belt pulley crankshaft from year of manufacture '83. Since this screw has a left-hand thread and can practically not come loose, it is fixed with a maximum of 80 Nm! M14 x 55 x 1,25 Width across flats 22mm

1. oversize - 0,254 mm, set (8 pieces) engine type 123 1800/2000ccm ( pulley on crankshaft for several belts )

The spacer comes with seals already installed on both sides. Dimensions: Total thickness: 13.2 mm Height: 52 mm Width: 60 mm Hole spacing: 43 mm

Mechanical fuel pump for CS2 2000 carburettor models. Alternatively electric fuel pump for carburettor models Art. No. 1164073 Advantage: Fuel is always immediately available at the carburettor and the annoying "georgele" until fuel...

Fuel pump for injector models Alternative to the BOSCH pump Attention: If your pump is defective, make sure to check whether there is rust or other impurities in your tank, as the fuel is only cleaned after the pump! If you do not take...

Attention: If your pump is defective, make sure to check whether there is rust or other impurities in your tank, as the fuel is only cleaned after the pump! If you do not take this into account, the new pump will also fail quickly! Info:...

Fiat 124 Coupé/Spider 14/16/1800 Fiat 125 - Fiat 125 S Fiat 132 GL/GLS 16/1800

Oil pump incl. oil pump seal for 1800 US models Fiat 124 Spider 1800 USA Fiat 131 Super 1600 Fiat 132/1600

Original used, stripped, straightened and repainted. Dimensions: Length: 453mm Width: 228-248mm Height: 125mm

The steel baffle plate for 2000 oil pan must be welded into the oil pan. from 79-85 Model CS2/CS0/DS/VX

Dimensions: Length: 452 mm Width: 602 mm Pipe outer diameter: 24 mm Pipe inner diameter: 22 mm Material thickness: 3 mm Depth: 14 mm

Fiat 500 - Fiat 126 - Fiat 600 - Fiat 850 Fiat 127 - Fiat 128 - Fiat X 1/9 Fiat 124 N/S/Coupe/Spider Fiat 125 - Fiat 125 S Fiat 131 - Fiat 132 Fiat 238 Fiat 11/1200 - Fiat 1200 Cabrio

Attention: Overall height 57 mm Illustration similar

Oil filter flange: Part milled from the solid. Visually similar to the original. Fasten with original screws! Clearly our recommendation!

Inner diameter: 22 mm Outer diameter: 27.5 mm

Caution: During installation, only lightly tighten the end connecting to the air flow meter so that it can still be pulled off by hand. If you tighten it too much, the air flow meter could be damaged in the event of a backfire! If the...

We recommend changing the intake hose, as it becomes hard over time. Order number: 1164088 Important installation advice: When fitting the air flow meter, do not secure the air hose in the direction of the throttle valve with hose tape...

Temperature range: 25-80°C Colour of the head may vary. Fiat 124 Spider CS2, CS0 2000ie Fiat 124 DS Pininfarina 2000ie Fiat 132 Argenta ie Lancia Beta ie

For vehicles where the alternator bracket is on the oil filter flange.

For Weber 1978 32ADFA 2/100, 1979-80 WEBER 28/32 ADHA, carburettor idle shut-off valve with 8 x 1.0 mm thread