No results were found for the filter!
Art.-Nr. 1162206
With absatz for valve stem seal
€9.95 *
Art.-Nr. 1162207
Length 42 mm Outer diameter 15.05 mm Inner diameter 8 mm With Absatz for valve stem seal
€9.95 *
Art.-Nr. 1162211
Fiat 124 Coupé/Spider Fiat 125 - Fiat 125 S Fiat 128 N/Coupé/3P Fiat X 1/9 Fiat 130 Berlina/Coupé Fiat Dino Coupé /Spider 2400 Outer diameter: 37mm Height: 30.7mm
€16.95 *
Art.-Nr. 1162212
Fiat 124 Sport Coupe / Spider Fiat 125 - Fiat 125 S Fiat 130 Berlina / Coupe Fiat X 1/9 13/1500 - Fiat 128 Fiat 131 - Fiat 132 - Lancia Beta
€7.75 *
Art.-Nr. 1162216
Camshaft inlet (cam width approx. 20mm)
€209.95 *
Art.-Nr. 1162222
304 degrees, 10.6 mm stroke timing 42-82-82-42, 84 degrees overlap Valve clearance 0.35mm Outlet and inlet Only suitable for highly modified engines! These camshafts should only be installed in combination with, for example, one or two...
€449.95 *
Recommended
Art.-Nr. 1164108
We recommend changing the intake hose, as it becomes hard over time. Order number: 1164088 Important installation advice: When fitting the air flow meter, do not secure the air hose in the direction of the throttle valve with hose tape...
€779.95 *
Art.-Nr. 1162229
Temperature range: 25-80°C Colour of the head may vary. Fiat 124 Spider CS2, CS0 2000ie Fiat 124 DS Pininfarina 2000ie Fiat 132 Argenta ie
€18.95 *
Art.-Nr. 1164089
Original Bosch 0280 130 214 Temperature timer switch is responsible for controlling the cold start valve. The thermal timer limits the injection time of the cold-start valve depending on the engine temperature. It is housed in a hollow...
€224.95 *
Art.-Nr. 1164106
The electric start valve ensures that the air in the manifold is enriched with finely atomised fuel. However, the electric start valve only injects when the starter is actuated and a thermal timer in the cooling water is closed at the...
€299.95 *
Art.-Nr. 1164075
We recommend art. no. 1164064
€139.95 *
Engine control unit original Bosch used Fiat 124 Spider DS
Art.-Nr. 1162239g
The control unit, as the central unit, evaluates the data supplied by the sensors about the engine's operatingbsstatus. It uses this data to form control pulses for the injection valves, whereby the amount of fuel to be injected is...
€1,249.95 *
Art.-Nr. 1164064
Modified means: Second-hand overhauled and with advance as soon as you switch on the ignition. The car therefore starts much better. The pre-run runs for approx. 8 seconds, after which the relay switches off automatically . We grant a...
€149.95 *
Art.-Nr. 1164105
Be sure to grease sufficiently before installation! Lenght: 600/400mm
€19.95 *
Art.-Nr. 1162247
Thread size: M10 Diameter: 1.25mm Length: 120mm
€5.95 *
Art.-Nr. 1162249
Set of bearing shells auxiliary shaft Large bearing: Outside 51 mm Inside 48.5 mm Small bearing: Outside 42.5 mm Inside 39 mm Attention: Follow installation instructions
€49.95 *
Art.-Nr. 1162250
Oil filter flange with 2 connections (1x oil pressure switch for indicator light), (1x oil pressure sender for oil pressure instrument )
€129.95 *
Art.-Nr. 1162256
Crankshaft Bearing Shell Set 1st Oversize - 0.254mm Engine TYPE 132 1592 cc
€49.95 *
Art.-Nr. 1162257
2. oversize 0,508mm, set (8 pieces) 1800/2000ccm ( crankshaft front with pulley for several belts)
€85.95 *
Art.-Nr. 1162261
8 pieces asimetric bore, journal 48.22 mm, thickness 1.53 mm Engine type 125 BC, 1608 69-73 Fiat 124 Spider/Coupe
€50.95 *
Art.-Nr. 1162263
For vehicles where the alternator bracket is on the oil filter flange.
€4.49 *
Art.-Nr. 1162265
Outer diameter: 23mm Installation diameter: 16 mm Inner diameter: 11mm Height: 10mm
€4.90 *
Art.-Nr. 1162268
Maße: Außendurchmesser: 15 mm Innendurchmesser: 13 mm Breite: 10 mm
€3.75 *
Art.-Nr. 1164008
Carburettor gasket set 34 DCHE with diaphragms, needle valve stem, filter, gaskets, O - rings, U - washers
€25.95 *
Art.-Nr. 1164012
Carburettor gasket set 32 ADFA 1/100 with diaphragms, needle valve, filter, gaskets, O - rings, U - washers 1800 US
€29.79 *
Recently Viewed