Oil filler plug with external hexagon 17mm conical sealing thread 22x1.5 - Rear axle - Gearbox Lateral for gearbox oil check and filling - Oil pan

Screw cross strut to body and compression strut to axle beam M12x1.25x70

Screw long for mounting compression strut on body Fiat 124 Spider / Coupe / Sedan

Screw for fastening longitudinal strut in axle beam and to body Fiat 124 Spider / Coupe / Saloon and screw for hardy washer

Longitudinal strut mount on body

Gearbox bearing drive shaft front 75/30/19 CS/DS Fiat 124 Spider, Coupé - Premium Quality

Scope of delivery: piston set 4 pieces, 4x piston pin, 8 circlips for piston pin

Flywheel with sprocket Automatic until Bj. 83 used

Carburettor gasket set VX 36 DCA incl. diaphragms, needle valve stem, gaskets, filter, O - rings, U - washer

Separator Backelit with paper gaskets for 44 WEBER / Solex double carburettor e.g.: 44 IDF

Reducer for cooling water hoses from 8 to 13 mm for expansion tank up to year of construction 84 Fiat 124 Spider

Fuel tank nozzles from 78 Leaded short stub, with reduction Only used !!!

WEBER 34 ADF carburettor idle shut-off valve

Carburettor gasket set LARGE 34 ADF with diaphragms, needle valve stem, filter, gaskets, partial nozzles, partial throttle plates, stud bolts, O-rings, U-discs

Carburettor gasket set LARGE 2000 carburetor 78-79, Weber 28-32 ADHA with diaphragms, needle valve, filter, gaskets, partial jets, partial throttle plates, studs, O-rings, U-washers.

Carburettor gasket set 32 ADFA 15/101 with diaphragms, needle valve stem, filter, gaskets, O - rings, U - washers

Carburettor gasket set LARGE 32 ADFA 15/101 with diaphragms, needle valve, filter, gaskets, partial nozzles, partial throttle valve plates, stud bolts, O-rings, U-discs

Carburettor gasket set LARGE SOLEX 34 EIES with diaphragms, needle valve, filter, gaskets, partial nozzles, partial throttle valve plates, stud bolts, O-rings, U-discs

Carburettor gasket set LARGE 34 DHS with diaphragms, needle valve, filter, gaskets, partial nozzles, partial throttle valve plates, stud bolts, O-rings, U-discs

Carburetor gasket set LARGE 40 IDF with membranes, needle valve, filter, seals, some nozzles, some throttle valve plates, stud bolts, O-rings, U-washers

Carburetor gasket set LARGE 44IDF with membranes, needle valve, filter, seals, some nozzles, some throttle valve plates, stud bolts, O-rings, U-washers

Carburetor gasket set 34 DFH with membranes, needle valve, filter, seals, O - rings, U - washers

Carburetor gasket set LARGE 34 DFH with membranes, needle valve, filter, seals, some nozzles, some throttle valve plates, stud bolts, O - rings, U - washers

Exhaust manifold 14/16/1800 Euro Fiat 124 Spider (flange with 4 screws) Used part !!!!

Total length = 450mm There is no seal (even OEM) between the adjacent exhaust pipes and the catalytic converter! We recommend sealing the exhaust system in front of and behind the catalytic converter replacement pipe with exhaust...

Exhaust pipe centre / pre-silencer (4-hole flange) Fiat 124 Spider Volumex 83-85 - centre silencer

Exhaust clamp (clamping bracket)

Before installation, be sure to check the contacts on your vehicle and clean them if necessary! If the contacts are worn, we recommend installing a relay for the light control!

Light / indicator switch BS/BS1 / BC 1970 - 1972 Before installation, be sure to check the contacts on your vehicle and clean them if necessary! If the contacts are worn, we recommend installing a relay for the light control!