No results were found for the filter!
Art.-Nr. 1164115
Carburettor gasket set VX 36 DCA incl. diaphragms, needle valve stem, gaskets, filter, O - rings, U - washer
€69.95 *
Art.-Nr. 1164116
Separator Backelit with paper gaskets for 44 WEBER / Solex double carburettor e.g.: 44 IDF
€11.95 *
Art.-Nr. 1164117
€18.95 *
Art.-Nr. 1160132
Reducer for cooling water hoses from 8 to 13 mm for expansion tank up to year of construction 84 Fiat 124 Spider
€9.95 *
Art.-Nr. 1164118g
Fuel tank nozzles from 78 Leaded short stub, with reduction Only used !!!
€34.95 *
Art.-Nr. 1164120
WEBER 34 ADF carburettor idle shut-off valve
€38.95 *
Art.-Nr. 1164121
Carburettor gasket set LARGE 34 ADF with diaphragms, needle valve stem, filter, gaskets, partial nozzles, partial throttle plates, stud bolts, O-rings, U-discs
€69.95 *
Art.-Nr. 1164122
Carburettor gasket set LARGE 2000 carburetor 78-79, Weber 28-32 ADAH with diaphragms, needle valve, filter, gaskets, partial jets, partial throttle plates, studs, O-rings, U-washers.
€59.95 *
Art.-Nr. 1164123
Carburettor gasket set 32 ADFA 15/101 with diaphragms, needle valve stem, filter, gaskets, O - rings, U - washers
€29.79 *
Art.-Nr. 1164124
Carburettor gasket set LARGE 32 ADFA 15/101 with diaphragms, needle valve, filter, gaskets, partial nozzles, partial throttle valve plates, stud bolts, O-rings, U-discs
€59.95 *
Art.-Nr. 1164125
Carburettor gasket set LARGE 32 ADFA 1/100 with diaphragms, needle valve, filter, gaskets, partial nozzles, partial throttle plates, stud bolts, O - rings, U - washers 1800 US
€54.95 *
Art.-Nr. 1164126
Carburettor gasket set LARGE SOLEX 34 EIES with diaphragms, needle valve, filter, gaskets, partial nozzles, partial throttle valve plates, stud bolts, O-rings, U-discs
€59.95 *
Art.-Nr. 1164127
Carburettor gasket set LARGE 34 DMS with diaphragms, needle valve stem, filter, gaskets, partial nozzles, partial throttle valve plates, stud bolts, O - rings, U - washers
€69.95 *
Art.-Nr. 1164129
Carburetor gasket set LARGE 34 DEHE with membranes, needle valve, filter, seals, some nozzles, some throttle valve plates, stud bolts, O-rings, U-washers
€63.95 *
Art.-Nr. 1164131
Carburetor gasket set LARGE 44IDF with membranes, needle valve, filter, seals, some nozzles, some throttle valve plates, stud bolts, O-rings, U-washers
€59.95 *
Art.-Nr. 1164133
Carburetor gasket set 34 DFH with membranes, needle valve, filter, seals, O - rings, U - washers
€34.95 *
Art.-Nr. 1166060g
Exhaust manifold 14/16/1800 Euro Fiat 124 Spider (flange with 4 screws) Used part !!!!
€199.95 *
Art.-Nr. 1166062
Exhaust pipe centre / pre-silencer (4-hole flange) Fiat 124 Spider Volumex 83-85 - centre silencer
€235.95 *
Art.-Nr. 1166066
Exhaust clamp (clamping bracket)
€29.95 *
Art.-Nr. 1182047
Before installation, be sure to check the contacts on your vehicle and clean them if necessary! If the contacts are worn, we recommend installing a relay for the light control!
€174.95 *
Art.-Nr. 1182048
Light / indicator switch BS/BS1 / BC 1970 - 1972 Before installation, be sure to check the contacts on your vehicle and clean them if necessary! If the contacts are worn, we recommend installing a relay for the light control!
€249.95 *
Adjustable thermoswitch, with capillary probe
Art.-Nr. 1060001
Variable temperature switch, with capillary probe (approx. 1 metre long) Variable temperature range 0-120 ° C. Suitable for mounting in water hoses on the cooling network or various parts that are to be switched or monitored thematically.
€35.95 *
Art.-Nr. 1160130
When replacing the heater fan motor, the series resistor for the 1st stage of the fan is required.
€10.95 *
Art.-Nr. 1182046
For retrofitting electric power steering. For models with speedometer cable screw cap up to year of manufacture: 76 Fiat 124 Spider / Coupe
€39.95 *
Recommended
Art.-Nr. 1184065
This distributor was developed for the 4-cylinder FIAT 124, 131, Coupe, Spider and Abarth engines with double camshaft. The distributor is equipped with vacuum adjustment for Spider from 79-85. It replaces the originaldistributor which...
€409.95 *
Art.-Nr. 1162375
Crankshaft is supplied with corresponding bearing shells. The crankshaft has been reworked (ground, oil plugs removed and oil ducts cleaned). Please note: An old part that needs to be reworked must be returned for a deposit of 300 euros....
€650.95 *
Art.-Nr. 1164138g
Air filter box for CS1 1800 Spider/Coupe. Also suitable for CS2 - 2000
€149.95 *
Recently Viewed