Fuel tank nozzles from 78 Leaded short stub, with reduction Only used !!!

Tank hose 18/2000 Fiat 124 Spider For models from 1977 - 1985 Inner diameter: 50mm Outer diameter: 58mm

WEBER 34 ADF carburettor idle shut-off valve

Carburettor gasket set LARGE 34 ADF with diaphragms, needle valve stem, filter, gaskets, partial nozzles, partial throttle plates, stud bolts, O-rings, U-discs

Carburettor gasket set 32 ADFA 15/101 with diaphragms, needle valve stem, filter, gaskets, O - rings, U - washers

Carburettor gasket set LARGE 32 ADFA 15/101 with diaphragms, needle valve, filter, gaskets, partial nozzles, partial throttle valve plates, stud bolts, O-rings, U-discs

Carburettor gasket set LARGE 32 ADFA 1/100 with diaphragms, needle valve, filter, gaskets, partial nozzles, partial throttle plates, stud bolts, O - rings, U - washers 1800 US

Carburettor gasket set LARGE SOLEX 34 EIES with diaphragms, needle valve, filter, gaskets, partial nozzles, partial throttle valve plates, stud bolts, O-rings, U-discs

Carburetor gasket set LARGE 34 DCHE with membranes, needle valve, filter, seals, some nozzles, some throttle valve plates, stud bolts, O-rings, U-washers

Carburetor gasket set LARGE 40 IDF with membranes, needle valve, filter, seals, some nozzles, some throttle valve plates, stud bolts, O-rings, U-washers

Carburetor gasket set LARGE 44IDF with membranes, needle valve, filter, seals, some nozzles, some throttle valve plates, stud bolts, O-rings, U-washers

Carburetor gasket set 34 DFH with membranes, needle valve, filter, seals, O - rings, U - washers

Carburetor gasket set LARGE 34 DFH with membranes, needle valve, filter, seals, some nozzles, some throttle valve plates, stud bolts, O - rings, U - washers

Exhaust manifold 14/16/1800 Euro Fiat 124 Spider (flange with 4 screws) Used part !!!!

Exhaust pipe centre / pre-silencer (4-hole flange) Fiat 124 Spider Volumex 83-85 - centre silencer

Exhaust clamp (clamping bracket)

Before installation, be sure to check the contacts on your vehicle and clean them if necessary! If the contacts are worn, we recommend installing a relay for the light control!

Light / indicator switch BS/BS1 / BC 1970 - 1972 Before installation, be sure to check the contacts on your vehicle and clean them if necessary! If the contacts are worn, we recommend installing a relay for the light control!

Fiat 850 N/S Fiat 850 Coupe Fiat 850 Spider Fiat 124 N/S Fiat 124 Coupe Fiat 124 Spider

Variable temperature switch, with capillary probe (approx. 1 metre long) Variable temperature range 0-120 ° C. Suitable for mounting in water hoses on the cooling network or various parts that are to be switched or monitored thematically.

When replacing the heater fan motor, the series resistor for the 1st stage of the fan is required.

For retrofitting electric power steering. For models with speedometer cable screw cap up to year of manufacture: 76 Fiat 124 Spider / Coupe

This distributor was developed for the 4-cylinder FIAT 124, 131, Coupe, Spider and Abarth engines with double camshaft. The distributor is equipped with vacuum adjustment for Spider from 79-85. It replaces the originaldistributor which...

Crankshaft is supplied with corresponding bearing shells. The crankshaft has been reworked (ground, oil plugs removed and oil ducts cleaned). Please note: An old part that needs to be reworked must be returned for a deposit of 300 euros....

Air filter box for CS1 1800 Spider/Coupe. Also suitable for CS2 - 2000

bsDue to the higher ignitiondsvoltage of the high-performance ignitiondscoil, the electrode gaps can be enlarged. This ensures better power development, smoother engine running and lower fuel consumption. These ignitiondscoils have an...